Then when i get to the "Configure Surround, i still get the same 4k per monitor resolution (10800 x 3840 in total, 3840x2160 per monitor)
Amd firepro w4100 chroma setting drivers#
Then booting in "allow unsigned drivers mode", i update the driver for each monitor with the created. Looking through the file, i find only mentions of 1920x1080 and lower resolutions so i did not make any changes to the. I also tried using Monitor Asset Tool, extracted an. I have tried using CRU 1.2.6 - in "Activate all displays" mode i have removed ALL resolution except 1920x1080 for all 5 monitors, 'no extension block', then sign out and in again, then "configure surround", but with the same result. The Nvidia Control Panel is a very poor and buggy application in this 5 monitor setup! If i then try to manually pick 5400x1920 as resolution for the full Surround, screens goes black for a few seconds but ends up back on 4k per monitor.Ī few rather obscure non-4k resolutions work - like 3840x1377 (1377x768 per monitor) and 5250x1400 (1400x1050 per monitor) (Portrait mode on monitors). You can imagine how slugish 5x4k gets even on dual GTX1080. In "Disable SLI" and "Activate all displays" mode there is no problem choosing correct resolution, but whenever i run "Configure surround" in Nvidia control panel, it comes up with a 10800 x ~3000 24Hz resolution. The monitors accept 4k input but then scales it down to their native HD res. Nec X555UNS (55") in portrait orientation connected through HDMI cables with DisplayPort adapters at the PC end. GTX 1080 in 2-way SLI (single flexible sli bridge) System: 6900k, 64Gb ram, Asus Rampage V Ed 10.
I have a PC that simply refuses to run the monitors at their native (recommended) 1920x1080 resolution when in Nvidia Surround mode.